How to install the Shower Filter

AquaTru Shower Installation

1. Before installation, please ensure the shower floor is dry.
2. MAKE SURE YOUR SHOWER IS TURNED OFF BEFORE INSTALLATION. INSTALLATION CANNOT BE DONE WHILE WATER IS RUNNING THROUGH INLET PIPE.
3. Remove your existing showerhead by hand. Use the wrench if needed. Also, remove any old Teflon tape that might be on the shower inlet pipe threads.
4. Wrap fresh Teflon tape on the threads of your shower inlet pipe. Three to four complete clockwise turns of the tape should be enough.
5. Your brand new AOT Shower comes with the filter inside the filter housing. All you need to do is install it. Screw on the Shower onto your shower inlet pipe. Use the wrench to tighten it. DO NOT OVERTIGHTEN!
6. To flush the new shower filter, run your shower on cool for 1 minute.
7. You are now ready to enjoy the best shower of your life! Use the stream adjuster on the face to choose your favorite setting.